When SVCD calls ImgBurn, burning pauses for input.

[bobarnett]

When I set SVCD2DVD in motion to create and burn (using ImgBurn) and then, after SVCD2DVD performs it's stuff and calls ImgBurn to perform it's stuff, a message comes up that says, " ImgBurn: Test mode is not supported by the current media (DVD+RW). Data WILL actually be written to the disc. Would you like to continue anyway?"
All this is well and good except that often I have set the process in motion as I'm leaving and expect the whole thing to be done when I return as it always has in the past. Unfortunately, now when I return there sits the question that has been awaiting an answer for many hours.
I looked at ImgBurn settings within ImgBurn and within SVCD2DVD and could find nothing to change that would prevent this.
Any ideas?

[LIGHTNING UK!]

On the main ImgBurn screen, untick the 'Test Mode' option.

[bobarnett]

Well, once again, the obvious eludes me. I was looking deep into ImgBurn's menus, not on the main screen. Thanks for the tip.