Tmpgenc question

[jxD]

ok , i cut my movie in half and i encoded or whatever the first half , how do i get the other half of the movie to encode???i cant seem to figure it out

[bugster]

ok , i cut my movie in half and i encoded or whatever the first half , how do i get the other half of the movie to encode???i cant seem to figure it out

Well, that depends how you cut the movie in half

[jxD]

i used the tmpgenc to cut it , i set it at the begining then hit start then , the middle, then the end and hit the end and then cut it. if that makes any sense

[jxD]

now in my folder i have the one half of the movie, but i dont see an option in the tmpge program that says encode other half or anything

[jxD]

see the "Common Tmpgenc problems" post up top , i followed those instructions

[jxD]

now when i tried to burn that half i did on nero it cant reconize it and wont add the file to burn. the file was AVI and after i encoded it with TMPGEnc it made it an mpeg. damn this shit is confusing

[bugster]

i used the tmpgenc to cut it , i set it at the begining then hit start then , the middle, then the end and hit the end and then cut it. if that makes any sense

Not much. Are we talking TmpGenc mpeg-tools merge&cut feature?

the file was AVI and after i encoded it with TMPGEnc it made it an mpeg.

It would, thats what TmpGenc is for

What is your final destination? Is it VCD, SVCD or DVD ?

[jxD]

SVCD

[jxD]

bump

[Baldrick]

please wait a few days before bumping your topic. 12 minutes bumping isn't okey.

[jxD]

sorry, im just so close with this i wont do it again

[VCDHunter]

sorry, im just so close with this i wont do it again

Did you cut the avi in half or just encode the 1st half using the source range feature in tmpgenc ?

If you cut the avi in half simply repeat what you did with the first avi.

If you used the source range feature in tmpgenc simply change the source range to encode the 2nd half.

Whaats the problem here ?

[anglia]

from what i can see u have cut a whole movie somewhere in the middle .
when u saved your first half of the film did u save it as another file name.?

if u did not - then the whole film has been overwritten by ur first cut .
if u saved it as another file name then its ok . open tmgenc merge and cut open the whole film again. set the start time in the middle( the end from the first half of the film and set end at the end of the film save output file with a different name than the original whole film - now u have ur second half or the film.


good luck[/code]