VideoHelp Forum




+ Reply to Thread
Results 1 to 5 of 5
  1. I just bought the ND3520A drive but it didnt come with any installation instructions so i don't know how to install it properly. Could anyone tell me I'm supposed to do this, i went on the nec website and they have the instructions but its in deutche.
    Quote Quote  
  2. all u need to do is pull out your old drive and plug in the ide cable. on the top it shows how to make it a slave or master or whatever. it should be on defult slave. plug in and go
    Jessica Alba #1
    Quote Quote  
  3. Member Xylob the Destroyer's Avatar
    Join Date
    Sep 2004
    Location
    Earth, for now
    Search Comp PM
    some (definitely NOT all!) DVD burners can ONLY be installed as the Master Drive on the 2ndary IDE slot with no slave attached
    after it's installed you can then add a slave drive, but if you want/need to update the firmware, you must unplug your slave device

    again, this is only on SOME DVD burners, NOT ALL.
    YRMV
    "To steal ideas from one person is plagiarism; to steal from many is research." - Steven Wright
    "Megalomaniacal, and harder than the rest!"
    Quote Quote  
  4. Just jumper the drive to Cable Select, no worries
    Quote Quote  



Similar Threads

Visit our sponsor! Try DVDFab and backup Blu-rays!