VideoHelp Forum




+ Reply to Thread
Results 1 to 2 of 2
  1. 10th Feb 2004 10:51 #1
    stemy
    stemy is offline
    Member
    Join Date
    Feb 2004
    Search Comp PM
    I was flashing my DD0203 to firmware v2.50 and lost power in the middle of the flash. Now the computer will hang on "Detecting IDE devices" if the DD0203 is plugged in. Without the DD0203 plugged in, there are no boot issues at all. I realize that flash + power loss = bad, but does anyone know anything that might bring the drive back?
    Quote Quote  
  2. 10th Feb 2004 12:26 #2
    Ziffelpig
    Ziffelpig is offline
    Member Ziffelpig's Avatar
    Join Date
    May 2003
    Location
    Soviet Canuckistan
    Search PM
    Send a message via ICQ to Ziffelpig Send a message via MSN to Ziffelpig Send a message via Yahoo to Ziffelpig
    I think your screwed but you can try MtkWinFlash
    http://digi.rpc1.org/mwf.htm
    And go here there is better info/help on firmware
    http://forum.rpc1.org
    Just shut up and listen dumbass
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!