Error with CCE and DVD2SVCD

[doctormidnight]

Using DVD2SVCD version 1.21 build 2 (latest) and Cinemacraft Encoder version v2.67.00.11

Ripping works fine, and the audio extraction works normally as well. But when CCE starts up, it gives the following error in the log file, and I have to manually click on the "encode" button, which is quite the pain in the butt since I want to set it and leave most of the time. Here is the log error:


Executing Cinema Craft Encoder.
Error cannot find CCE project file.

Has anyone else had this problem, or is there some setting that I have overlooked? When I push the "encode" button, it starts just fine (I'm still waiting for this one to finish), so I could use a little knowledge here. Thanks.

[Adder_78]

The demoversion of CCE 2.6X cant save the ECL file... try this EclCCE trick:
http://forum.doom9.org/showthread.php?s=&threadid=50287

8)

[doctormidnight]

Oh, that was so simple it's worse than getting an arrow in the neck and then discovering there's a gas bill tied to it! Thanks for the tip!