dvd2dvd2 1.4.9 error - Path not found on GO.

[LordSirOb]

I hope someone can shed some light on a problem I am having with dvd2dvdr. I am attempting to back up NTSC dvds using MrBass's guide. I used DVD Decrypter in file mode and ripped all files to a NTFS drive. I pointed the input file in dvd2dvdr to the ripped VIDEO_TS folder, and pointed the output file to another folder on the same drive (the folder name did not contain any non-letter characters). All other directions were followed per the guide. I used CCE for the re encode. When I pressed "GO," the log file complained about an error of "Path not found" after the Outputfolder check was started. I tried different output directories and names, using MainConcept instead of CCE for encoding, and different dvds. However, I can't even get .0001 milliseconds past the "GO."

Any help out there for this problem?

[thingimijig]

have you browsed to your cce .exe file under mpeg encoder.

could be that!

thingimijig.

[LordSirOb]

have you browsed to your cce .exe file under mpeg encoder.

could be that!

thingimijig.

I only wish my problem was that simple. However, all browsed paths were correct.

[thingimijig]

have you tried letting dvd2dvdr rip your files, takes a little longer but may work.

thingimijig.