VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 2nd Jan 2003 20:46 #1
    sugarstheway
    sugarstheway is offline
    Member
    Join Date
    Jan 2003
    Location
    Canada
    Search Comp PM
    I've been trying to burn an svcd with vcdeasy, but continue to get an error at the end stating that there is no driver found for my cd-rw drive. But when I check in device manager it shows one. It also says that it cannot setup device 1,0,0. I tried to use "Force Driver" but that doesn't work either. Any suggestions?
    Quote Quote  
  2. 2nd Jan 2003 21:16 #2
    hwoodwar
    hwoodwar is offline
    Member
    Join Date
    Sep 2002
    Location
    Seaside, CA
    Search Comp PM
    After you installed the ForceASPI drivers, did you:

    1. Reboot?
    2. In the bottom right corner did it state "ASPI seems valid: yes"
    3. Go to the CDRDAO settings page and select generic-mmc as the force driver for the CD Writer
    4. Select your specific CD Writer in the dropdown menu of the CD Writer section
    5. Put a check in the "force execution" box
    Quote Quote  
  3. 2nd Jan 2003 22:31 #3
    Conquest10
    Conquest10 is offline
    Member Conquest10's Avatar
    Join Date
    Sep 2002
    Location
    Chicago, IL
    Search Comp PM
    that's wierd. mine always says "ASPI seems valid: No" and i have no problem with burning with vcdeasy.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!