Lines when Ripping DVD w/ Smart Ripper

[WackoClwn]

Hello,
I'm a long time reader, first time poster. I'm not that advanced with ripping DVD's, but I consider myself knowledgable. Currently I have ripped the VOB files from my Shrek DVD to my hard drive using smart ripper, and have frameserved it with DVD2AVI. I open the .d2v in TMPEG and I select my settings to encode it to SVCD. When I go to preview, to see what my output will look like, I get lines running across the frames. It does not happen at every frame, but seems to occur very often. I have noticed this with other DVDs I have tried to rip, and I can not find anything which mentions how to fix this. If someone could please recommend to me a way to fix the lines running across the frames I would be grateful. Thanks. It seems to occur when there is some sort of action, not when the characters are just sitting around.

[CryptKeeper]

something like this?

http://forum.vcdhelp.com/viewtopic.php?t=91495&start=0&postdays=0&postorder=asc&highlight=dvd svcd using dvd2avi frameserving tmpgenc

[CryptKeeper]

this is what you gotta look for in DVD2AVI

Frame Rate = 25.000 fps: your source is PAL and you can skip the following step.

Frame Rate = 29.970 fps: Let the preview run for a couple of minutes, then take a look at the Video Type: If it's FILM at a percentage higher or equal to 95% you can activate Forced FILM as shown below. Otherwise you will have to perform IVTC(InVerse TeleCine).

in DVD2AVI
for Inverse Telecine - click on Video -> Field Operation -> None
for Film 95% and higher - click on Video -> Field Operation -> Forced Film

then you gotta set the Inverse Telecine in TMPGenc

but all I see is this
TMPGenc
Setting -> Advanced -> [x] Inverse Telecine (Convert to 24fps: Non-Interlace source)

hope someone else can elaborate on this

[WackoClwn]

Thank CryptKeeper, that was exactly what I was looking for

[CryptKeeper]

no prob