VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 31st Mar 2004 17:09 #1
    RobinB
    RobinB is offline
    Member
    Join Date
    Mar 2004
    Search Comp PM
    I get a No Disc message when I put a CD in the machine. The laser appears to be OK but the motor does not start. I can get a bunch of messages using the remote plus the front panel buttons. Can I troubleshoot this way or intialize the software (assuming it is corrupted)? What is the most likely cause if the motor does not start? Could it be the motor itself or driver circuitry. Any help on where to look next appreciated.
    RobinB
    Quote Quote  
  2. 31st Mar 2004 19:12 #2
    louthewiz
    louthewiz is offline
    Member
    Join Date
    May 2003
    Location
    United States
    Search Comp PM
    Your motor is shot or sure ,if you really like the unit take it to an authorized repair shop its going to cost about $75.00 ,but for that price you can buy a new one...
    Quote Quote  
  3. 31st Mar 2004 19:31 #3
    handyguy
    handyguy is offline
    Member
    Join Date
    Mar 2003
    Search Comp PM
    Mine did that to, I just took the top off & gave that white circular cog a little push & its been fine. With the top off, keep your face from that laser eye.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!