VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. Is there any way to get a full screen preview of my created menus?
    Quote Quote  
  2. There isa simulate, but the only way to get a full screen test is to compile the project. Not a big deal, go into the compile options and select "test compile". This will replace the movies that you created with dummy movies. The compile will take a few seconds. Essentially this mode was built to do what you are asking for. To test the functioning of the menus and transitions without the lengthy compile of doing the whole thing.

    You can then use PowerDVD or WinDVD to preview the menus.
    Quote Quote  
  3. Figured it out. Menu > Simulate.
    Quote Quote  



Similar Threads

Visit our sponsor! Try DVDFab and backup Blu-rays!