Scenalyzer Will Not Capture. Other Programs Do.

[jsw140]

I am using a Dazzle Hollywood Bridge connected to an Adaptec Firewire card. . Scenalyzer shows Microsoft DV Camera and VCR as the capture choice. Scenalyzer does not seem to be getting any input though. When I start Capture, it gets nothing. After 20 secs. the capture turns off.
Windows Movie Maker, MyDVD, Moviestar 5.2, Moviestar 5.3, and DVDComplete capture fine from the Hollywood Bridge.
My system iis a 3.06 GHz w/ 1.5 GB ram, ATI 9700 Pro, and WinXP Pro. I am using the 6/28/03 version. The same happened with earlier versions.

On my old 450 MHz pentium system with Win2000 I could capture with both Scenalyzer, and, all these other programs (except Windows Movie Maker, which I did not have on that system)

Any ideas?

[Redd]

Are you using the latest verisn of scLive? It's for Digital only.

[jsw140]

I tried the latest version. I tried the 11-15-02 version and the 050902 version. None of them worked. The 11-15-02 and 05-09-02 versions definitely worked before on my win2000 system.
I am not sure what you mean by saying that the latest version is only for digital. The Hollywood DV Bridge takes analog from my camcorder and generates DV out into the firewire port. It should look the same as if I had hooked up a digital camcorder to the firewire port.
I am a registered owner of Scenalyzer. I asked this same question at the scenalyzer website but did not get a reply.