In the Cutting and Splitting section of VSDC, I am trying to trim and edit out sections of a video. Trimming the ends is not a problem, but trying to cut out sections in the middle is driving me nuts.
I use the cursor to find the approximate place I want to start the edit, and use the controls at the bottom to increment to the exact place I want, then I drag the cursor to the approximate place I want to end the edit, but as soon as I try to increment the end of the selection using the controls, the start of the selection moves as well.
I cannot just use the cursor to find the exact end because it is not accurate enough, and I cannot for the life of me figure out how to pin the start point so that it does not move when I try to increment the end. I have tried adding markers, and tried clicking the "Start selection" button, but none of it works... if I increment the end selection forward 5 seconds, the start selection also increments forward five seconds, and the cut ends up in the wrong place.
Frustrating!
Try StreamFab Downloader and download from Netflix, Amazon, Youtube! Or Try DVDFab and copy Blu-rays!
+ Reply to Thread
Results 1 to 1 of 1
Thread
Similar Threads
-
VSDC cutting off the beginning of a vid
By Moffu in forum EditingReplies: 2Last Post: 21st Jul 2020, 10:16 -
Cutting/Splitting .VOB
By erzane in forum EditingReplies: 8Last Post: 31st Jan 2020, 07:03 -
VSDC cutting/splitting slowed down video
By bigchief247 in forum Newbie / General discussionsReplies: 2Last Post: 9th Apr 2019, 23:38 -
VSDC Video Editor - How to highlight/"circle" out selected area of video?
By George Tang in forum EditingReplies: 2Last Post: 4th Nov 2017, 04:51 -
Cutting/Splitting video in specific parts with avisynth?
By killerteengohan in forum RestorationReplies: 34Last Post: 2nd Mar 2017, 18:18