Hi All. I'm trying to cut a full lenth MPEG1 file in TMPGEnc so that I can burn it to 2 VCDs. When I try to cut it, it can't read past 50:24:15 in the movie. It always stops there. I've seen the exact same copy of the movie on the internet, usually in 2 pieces, so I suspect that someone put it together at some point and I got that copy. I tried to use 50:24:15 as the cutpoint and it still can't read past that to do the 2nd MPEG. I tried to go as far ahead as 50:30:00 to start the 2nd MPEG (Who cares about 6 seconds if I can just get this burned! ) and it still doesn't work. I then tried to multiplex the file in TMPGEnc hoping it would fix whatever is wrong and it didn't get past 50:24:15 either. The movie plays fine on the computer, but it's annoying not being able to burn it and watch it on TV. Any ideas? Thanks in advance.