strange problem converting widescreen avi > mpeg2 with tm

[Juzee]

usually I can convert my divx to dvd complaint mpeg2 no probs with tmpgenc, but this particular one is causing me problems...

the source avi:


the output mpeg2:


any ideas what I'm doing to cause this? Is there a setting I'm missing?

Cheers...
Juz

[puertorican138]

Video Tab:

Size: 352x240
Aspect Ratio: 4:3 525 line (NTSC)
Frame rate: 29.97 fps

Advanced Tab:

Video source type: Non-interlace (progressive)
Field order: Bottom field first (field B)
Source aspect ratio: 1:1 (VGA)
Video arrange Method: Full screen (keep aspect ratio)

Hope That Helps!!! :P

[Juzee]

thanks, I'll give that a go!

[puertorican138]

thanks, I'll give that a go!

I hope you're going to get the results your looking for!!! :P

[tokyootaku]

When converting an AVI file.. do you need to decompress the AVI PCM files first before converting to MPEG2 [DVD Format] . Advise needed... is it possible if someone can give me the settings or the mcf file? Thanks

[Juzee]

Ok I tried that but it wouldn't let me change the aspect ratio under the video tab, it was greyed out Tried with the rest of the settings though and it had the same result so I'm guessing that bits fairly important?

[puertorican138]

If the greyed out Aspect ratio under the Video Tab was 4:3 then your OK.

[puertorican138]

Don't worry about 4:3 Aspect Ratio under the video tab as it's set by default anyway.

[puertorican138]

Source aspect ratio: 1:1 (VGA)
Video arrange Method: Full screen (keep aspect ratio)

Hope That Helps!!! :P