DVD maestro and cce

[einsi]

I encoded a movie with cce (using DVD2SVCD) and imorted that movie into maestro. When I was importing chapter points that I had ripped with Chapter Xtractor only 5 of them were imported but they should have been 16 chapter points. And the same goes out for the subtitles they don't all show up, little less or around half of them. When I encode with TMPGEnc everything imports correctly.

I rather wanna use cce, so any solutions would be great.

[BJ_M]

if you notice - cce starts with a time code mark of 1 hour and tmpgenc starts at 0

so either offset cce back to 0 or reset maestro time code to non asset based so that it also starts at 0 - then import your chapters ..

[mtgoat]

reset maestro time code to non asset based so that it also starts at 0

How does one do this? Thanks!

[BJ_M]

right click on time line on the left and select "zero based"

its in the manual ..