can"t burn files over 3 gb

[eagles]

i can't burn files over 3 gb. i encode a movie with tmpgenc and then author it with dvd movie factory but i get an error message when i try to burn the file that says there is not enough disk space but it shows 4.7gb free but if the file is under 3 gb i have no problems i have tryed both dvd+rw and dvd+r disks my burner is a hp dvd200i does anyone have the same problem or have any ideas what my problem might be ?

[canadateck]

Thanks

[eagles]

the error message says i don't have enough space on my dvd +r but it is a blank disk after i close the error message window in the determine output settings options window of dvd movie factory it says that i have 4.700 mb of avalible dvd space and my file size is well under that size ihave this problem everytime i try to burn a file over 3 gb if i reencode it to under 3 gb it works fine

[canadateck]

Thanks

[canadateck]

Thanks

[eagles]

soory i meant 4.7 gb and i am authoring the file with dvd movie factory right now and am going to try burning with nero i will post my results :P

[eagles]

ok i authored the 4 gb file with dvd movie factory then burned it with nero and no problems i am using the trial version of movie factory i wonder if this is a limatation of the trial version

[canadateck]

Thanks

[eagles]

does'nt say if there is any limatations when i play the movie from the disk i just burned with nero on my pc with power dvd it is very jerky but when i play it on my standalone player it is much better but still a little jerky in a spot or two when i play the encoded file on power dvd there is no jerkyness at all ialso have ulead dvd workshop i am going to try authoring and burning it with dvd workshop and see what happens