capture using premiere pro 2

[mamo]

i can't capture movies from a sony handycam dcr trv22e. I can actually capture using windows movie maker and the system recognizes the camera. But in premiere pro 2 there's a message that says me to reset the camera. what to do?

thank you
mamo

[edDV]

Call Adobe support?

A good alternative is to capture with WinDV (free) and then import the file into Premiere. Premiere2 is a resource hog and needs a hefty computer to run. WinDV is minimalist and should be more reliable for DV transfer on an average computer.

Looks like you are running on a laptop with a 40GB hard disk. Good luck getting Premiere Pro 2 running on that.

[mamo]

yes, shure this is a good alternative, i can also capture with windows movie maker. But i would like to know why it doesn't run. I used premiere 7 and i had no problems in capturing, but with premiere 2 doesn't go. I have installed the same premiere in my brother's pc and after connecting the camera everything was ok the movie was captured...my pc is a dell inspiron 510m laptop with an intel r pentium r m processor 1500 mhz - 1.5oghz - 512 mb di ram and premiere 2 runs very well when i do all the operations except capturing. Premiere actually "see" the camera but there's a message telling me that there are non controller for my camera. So i have tried to start the camera and starting a capture manually but it doesn't run...

[edDV]

yes, shure this is a good alternative, i can also capture with windows movie maker. But i would like to know why it doesn't run. I used premiere 7 and i had no problems in capturing, but with premiere 2 doesn't go. I have installed the same premiere in my brother's pc and after connecting the camera everything was ok the movie was captured...my pc is a dell inspiron 510m laptop with an intel r pentium r m processor 1500 mhz - 1.5oghz - 512 mb di ram and premiere 2 runs very well when i do all the operations except capturing. Premiere actually "see" the camera but there's a message telling me that there are non controller for my camera. So i have tried to start the camera and starting a capture manually but it doesn't run...

It may be that you don't have device control set correctly. You should call Adobe support.

Windows Movie Maker can do it if you know all the steps, but WinDV is a simple better DV capture program in my opinion.

[mamo]

ok thank you i will try to get some informations