Hi again
My monitor is beginning not switching on each time I start my mac..
The G4 starts fine but the monitor doesn't
Sometimes I have to kill the G4 twice before finally the monitor gives me a picture....Is it the monitor or my graphic card
Haribo
+ Reply to Thread
Results 1 to 3 of 3
-
-
Sometimes I have to kill the G4 twice before finally the monitor gives me a picture....Is it the monitor or my graphic card
and monitor cable to card, then it is most likely the monitor.
Monitor recieves signal from mac, which in turn causes it
accept and begin display of incoming signal.
Non acceptance of the signal usually points to the Monitor going bad.
read further here,
and also here."Everyone has to learn, so that they can one day teach."
------------------------------------------------------
When I'm not here, Where can I be found?
Urban Mac User
Similar Threads
-
Matshita BD UJ240AS doesn't work (not perform start of Disc-at-once)
By whenloverageswild in forum Authoring (Blu-ray)Replies: 5Last Post: 11th Nov 2011, 02:08 -
Computer Doesn't boot up monitor when turned on
By kerrex_2006 in forum ComputerReplies: 10Last Post: 23rd Dec 2009, 11:20 -
svcd2dvd doesn't start
By mapache in forum SVCD2DVD & VOB2MPGReplies: 4Last Post: 1st Feb 2008, 08:10 -
FLV conversion: playback doesn't start from 0 seconds.
By silentsteps in forum Video ConversionReplies: 0Last Post: 1st Dec 2007, 16:59 -
picture doesn't fill TV screen - let me back up and start over.
By ibzomie in forum Newbie / General discussionsReplies: 2Last Post: 15th Aug 2007, 21:48