VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 7th Jul 2004 22:44 #1
    YngwieJM
    YngwieJM is offline
    Member YngwieJM's Avatar
    Join Date
    Sep 2001
    Search Comp PM
    I just cloned my C: drive to another hard drive on my system using Norton Ghost. Does anyone know how to go about using that drive to boot from instead of my current C: drive? Is it just a case of removing the original C: drive from the system and putting the new clone in it's place on the primary IDE and the jumper in the master position? This sounds too easy to me. Any help would be greatly appreciated!
    I'd rather have a bottle in front of me than a frontal lobotomy.
    Quote Quote  
  2. 8th Jul 2004 00:13 #2
    stiltman
    stiltman is offline
    Hello Ladies stiltman's Avatar
    Join Date
    Jul 2003
    Location
    Studio 54
    Search Comp PM
    Yep, and don't forget to change the jumpers if you're using master/slave

    If you're using cable select, just change the drives on the ribbon cable
    tgpo famous MAC commercial, You be the judge?
    Originally Posted by jagabo
    I use the FixEverythingThat'sWrongWithThisVideo() filter. Works perfectly every time.
    Quote Quote  
  3. 8th Jul 2004 07:55 #3
    YngwieJM
    YngwieJM is offline
    Member YngwieJM's Avatar
    Join Date
    Sep 2001
    Search Comp PM
    Thanks much! I was hoping it was that easy. I'm going to give it a shot here in a minute or 2. Nice Mac video by the way!!!!!!!!
    I'd rather have a bottle in front of me than a frontal lobotomy.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!