New-B question regarding TMPGE

[The Stinger]

Can anyone tell me why I can't seem to load a d2v file in TMPGE? I get a error that says..."Cannot Open Or Not supported"...but yet there are times when it does load. I don't get what I am doing wrong to get it to load sometimes and other times not. Its starting to piss me off! I am using dvd2avi to create a d2v then load it into TMPGE. I have been following guides from this forum that act like it should load without any problems. I also took a look at the TMPGE sticky in this forum and did everything it said to do and it still didn't do it. Any help would be greatly appreciated.

[ZippyP.]

I also took a look at the TMPGE sticky in this forum and did everything it said to do......

Such as ....raising the Directshow priority?

[The Stinger]

I also took a look at the TMPGE sticky in this forum and did everything it said to do......

Such as ....raising the Directshow priority?

Yep, same error. I don't get it. It's like it can't read d2v files but yet I know it does. I think I give up. I will try another way, cause it's too much of a pain in the ass.

[fiw]

After creating your d2v File do NOT close DVD2AVI (it will act as a frameserver for TMPEGENC). Star TMPEGEnc and try to load your d2v file.
Works good for me so far

[The Stinger]

After creating your d2v File do NOT close DVD2AVI (it will act as a frameserver for TMPEGENC). Star TMPEGEnc and try to load your d2v file.
Works good for me so far

That worked thanks man! I figured it would take another new-b to figure my problem.