VideoHelp Forum




+ Reply to Thread
Results 1 to 5 of 5
  1. 26th Feb 2004 23:27 #1
    The Stinger
    The Stinger is offline
    Member
    Join Date
    Jan 2003
    Location
    United States
    Search Comp PM
    Can anyone tell me why I can't seem to load a d2v file in TMPGE? I get a error that says..."Cannot Open Or Not supported"...but yet there are times when it does load. I don't get what I am doing wrong to get it to load sometimes and other times not. Its starting to piss me off! I am using dvd2avi to create a d2v then load it into TMPGE. I have been following guides from this forum that act like it should load without any problems. I also took a look at the TMPGE sticky in this forum and did everything it said to do and it still didn't do it. Any help would be greatly appreciated.
    Quote Quote  
  2. 26th Feb 2004 23:41 #2
    ZippyP.
    ZippyP. is offline
    Member ZippyP.'s Avatar
    Join Date
    Nov 2002
    Location
    Lotus Land
    Search Comp PM
    Originally Posted by The Stinger
    I also took a look at the TMPGE sticky in this forum and did everything it said to do......
    Such as ....raising the Directshow priority?
    "Art is making something out of nothing and selling it." - Frank Zappa
    Quote Quote  
  3. 26th Feb 2004 23:53 #3
    The Stinger
    The Stinger is offline
    Member
    Join Date
    Jan 2003
    Location
    United States
    Search Comp PM
    Originally Posted by ZippyP.
    Originally Posted by The Stinger
    I also took a look at the TMPGE sticky in this forum and did everything it said to do......
    Such as ....raising the Directshow priority?

    Yep, same error. I don't get it. It's like it can't read d2v files but yet I know it does. I think I give up. I will try another way, cause it's too much of a pain in the ass.
    Quote Quote  
  4. 27th Feb 2004 01:11 #4
    fiw
    fiw is offline
    Member
    Join Date
    Jan 2004
    Search Comp PM
    After creating your d2v File do NOT close DVD2AVI (it will act as a frameserver for TMPEGENC). Star TMPEGEnc and try to load your d2v file.
    Works good for me so far
    Quote Quote  
  5. 27th Feb 2004 08:22 #5
    The Stinger
    The Stinger is offline
    Member
    Join Date
    Jan 2003
    Location
    United States
    Search Comp PM
    Originally Posted by fiw
    After creating your d2v File do NOT close DVD2AVI (it will act as a frameserver for TMPEGENC). Star TMPEGEnc and try to load your d2v file.
    Works good for me so far
    That worked thanks man! I figured it would take another new-b to figure my problem.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!