I'm caturing video with the HuffYUV codec. I load the avi into virtualdub, select Full Stream Processing for video (using the divx 5.1.1 codec) and direct stream copy for audio. For some reason my video always comes out blank -- the audio is fine.
I searched the boards but couldn't find anything useful for this problem. Anybody know what's up?
Thx
kisk
+ Reply to Thread
Results 1 to 5 of 5
-
-
Let me also say that when configuring the divx codec, encoding with 1 pass works fine and the video comes out. If I try to use multipass (1st, or 1st then nth) that's when I get no video. Any ideas?
-
kisk
I setup Divx for 'multipass 1st pass' then select "Save As Avi" select a name and check the box "Job Control". I then setup divx "multipass nth pass", select 'Save as Avi', choose the same file name and check the "Job Control" box again. I then open "Job Control" from the file menu. In job control just select 'Run' to create the 2 pass job.
It is also a good idea to set audio to full processing mode on the second pass as this will save you yet another process after Divx is completed.
Let me also say that when configuring the divx codec, encoding with 1 pass works fine and the video comes out. If I try to use multipass (1st, or 1st then nth) that's when I get no video. Any ideas?
Good luck. -
yeah I finally figured it out. The first pass with no video is what was throwing me off, but its good now. Using lame acm for the audio too. Thx
Similar Threads
-
No Huffyuv Codec under VirtualDub Compression
By Ryutso in forum Capturing and VCRReplies: 7Last Post: 28th Jan 2011, 02:31 -
Image sequence - VirtualDUB - HuffYUV - washed colors
By Bucic in forum EditingReplies: 35Last Post: 8th Oct 2010, 14:42 -
Blank video with MPEG2Source in Virtualdub but not Virtualdubmod
By txporter in forum Newbie / General discussionsReplies: 2Last Post: 31st Mar 2010, 15:17 -
Blank video when converting MP4 to AVI DivX
By vidnov in forum ffmpegX general discussionReplies: 16Last Post: 12th Mar 2010, 17:45 -
VirtualDub crash involving Huffyuv
By Xoanon in forum EditingReplies: 4Last Post: 15th Jun 2007, 17:33