Problem with ATI AIW 128 Pro 32mb MPEG-2 converting

[hotmat4]

When I capture in MPEG-2 through the ATI Multimedia Software, the quality is so much better than MPEG-1. But after capturing in MPEG-2, I can't open the file in any conversion tools eg TMPGenc. It can de-multiplex and then re-multiplex it again and can see the specs eg 480x480 and bitrate. TMPGenc says that the the file unsupported. Is there anyway of getting past this?

<font size=-1>[ This Message was edited by: hotmat4 on 2001-10-21 08:05:49 ]</font>

[uncle_joe]

Try load the file in virtdub and save it with divx compression.
After that I think the MPGenc will admite it as a good file.

[Stinky]

uncle_joe did you read his post? thats not good advice at all. to convert mepg-2 to divx so you can use it in TMPGEnc is a very bad suggestion. I dont have the answer for hotmat but I wanted to make sure he knew that converting it to an AVI format is NOT the answer.