"Directory Not Found" with SVCD2DVDMPG

[edsmith77]

Good Evening,
After browsing this site and reading the guides, I believe that SVCD2DVDMPG is the tool that I need.
I just downloaded the latest version (I think) V1.1.1.29641. And installed it. I also had to install the MS .Net pieces as well.

It will let me browse to the file I want to convert via the working directory input line and select the desired output. However, when I select RUN, I immediately get the following error message:
"Directory not Found C:\.........."

Obviously the directory exists or else the input file could not have been found.

Any suggestions on how to get past this problem??

Thanks,
Ed

[yf2001usa]

Hey,

I think svcd2dvdmpg has to be installed in the default directory

[ChrissyBoy]

Don't browse to the file, browse to the directory containging the file. SVCD2DVDMPG works on the contents of folders not individual files.

[edsmith77]

Thanks to all for your responses.

yf2001usa,
I did the install and let the installer put it where ever it wanted to. So I would presume that it went to the correct / default folder.

Chrissyboy.
I will try that. I could not seem to get access to the help in order to search. Some type of internet URL misassignment. Anyway, no help was available.
I will try pointing to just the folder and not to the file itself.


Another question. I noticed that most of the posts talk about using the + version. I presume that is the version that you can purchase after you decide you like the trial version? Or is there a trial version of + that is available. I could not seem to find it on the SVCD2DVDMPG site.

Once again, thanks

Ed

[ChrissyBoy]

"plus" version is now known as SVCD2DVD. There is a demo for SVCD2DVD: http://www.svcd2dvdmpg.com/SVCD2DVDMPG/Software/svcd2dvd_demo.aspx

CB