Component-video to VGA cable

[ashpitz]

Hi
I need to interconnect my DVD´s progressive-scan component-video output (3 RCA plugs) to my projector´s VGA input (15 pin DB connector).
can anybody offer a pinout diagram ?
My projector´s user´s manual says a simple adapter cable can do the job.
Thanks
Abraham

[DVD-SNIPE]

You might want to try RadioShack.

[ZippyP.]

I would try the manufacturer of the projector, either by phone or thru a website.

[BJ_M]

https://www.dcpuraty.com/dzs_020502/Product_Details.asp?ProductCode=IX1015V9R

http://www.a2zcables.com/a2zcables.storefront/3eb09d2907e75ffe271b424d361d0661/Product...View/V213&2D10

[ashpitz]

Thanks to all of you.
I live in Brazil , this is why I was asking for the cable´s pinout, so I could
assemble one here. On the local market this cable is not available.

[BJ_M]

http://www.acl.co.uk/pinouts.htm

[ashpitz]

Thanks BJ_M

[BJ_M]

1 2 3 and 6 7 8 is what is used in your case (non rgbhv)

[ashpitz]

Thanks again

I was wondering, if you only have the RGB and RGB-Ground, how do you get the picture synched?

[BJ_M]

I was wondering, if you only have the RGB and RGB-Ground, how do you get the picture synched?

he is using component-video - through a 15HD connector ... but in both component and RGB sync can be on green (in the case of RGB) or on all in the case of component.

RGB can be 3 wire, 4 wire or 5 wire

component is always 3 wire

RGB and component are not the same thing at all ...

Computers use RGB (RGBHV + signal)