VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 28th Jun 2011 22:00 #1
    comconct
    comconct is offline
    comconct
    Join Date
    Jun 2011
    Location
    Massachusetts
    Search Comp PM
    My HDTV displays message "no signal" after I connected my PC to it. I need to use VGA cable from and to - I don't have HDTV service.
    Quote Quote  
  2. 28th Jun 2011 22:17 #2
    edDV
    edDV is offline
    Member edDV's Avatar
    Join Date
    Mar 2004
    Location
    Northern California, USA
    Search Comp PM
    Originally Posted by comconct View Post
    My HDTV displays message "no signal" after I connected my PC to it. I need to use VGA cable from and to - I don't have HDTV service.
    More detail needed. VGA needs to be configured at the PC end and a reboot (TV and PC) may be required.
    Recommends: Kiva.org - Loans that change lives.
    http://www.kiva.org/about
    Quote Quote  
  3. 29th Jun 2011 09:00 #3
    jagabo
    jagabo is offline
    Member
    Join Date
    Dec 2005
    Search Comp PM
    Be sure to set the resolution to something that is supported by the TV. If you don't know what the TV supports try 1024x760 at 60 Hz. Make sure the computer has enabled the VGA port. With the TV and the computer off connect the two with the VGA cable. Turn on the TV, then turn on the computer. The computer should then see the TV is connected to the VGA port and you'll be able to enable the VGA port manually if it isn't automatically enabled.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!