ImageBurn 2.0 Setup Please

[mn072065]

Whats the best setting to use this program to burn images. Is the default correct. I took off verify because i did not want it, please is there as better settings to set it up or the default is ok. Thanks

[jtoolman2000]

I use nothing but default with an accoassional Verify is I really feel I need it.

[redwudz]

I wouldn't change from the default settings unless you really understand exactly what each control does. I did shut off the sounds, as I find them irritating, and I set the burn speed to 12X for my 16X media, but I leave the rest at default with no coasters yet. I didn't have any problems at 16X either, just a little insurance.

Are you having problems with your burns?

[mn072065]

Yes I get Waiting for buffers to recover... and Waiting for hard disk activity to reach threshold level.... I try to burn two at the same time.

[redwudz]

Try making the buffers sizes bigger may help. You can always set everything back to default. And if your hard drive is very full or hasn't been defragged in a while, you might make some improvements there. If you have only one hard drive with the OS on it, a second hard drive will improve throughput, also.

[mn072065]

I will try that. Would you happen to knwo how much bigger I can make it?

[mn072065]

I have my settings with interface STPI, shall I change that?