Video_TS to SVCD problems

[jcpudd]

I have done this many times in the past with ffmpegx. I downloaded the new version 0.0.9p and followed the install instructions.

Now when I try to encode a DVD (Ring, Underworld, Identity, and The Rundown) the Audio and Video are way out of sync. I have looked around for solutions but to now avail.

These are the options I am selecting:
Quick Presets: SVCD Mpeg2 Encoder
Framerate: Tried all of them (some are less out of sync then others)
Bitrate: 2500
Left audio on default settings
Decode with Quicktime: on (even though I get a pop up saying that mplayer will be used by default)

What am I doing wrong? I have ripped them using DVDbackup (like I always did before)

Please help
Thanks in advance
A

[major]

Have you tried the following: VOB input (no VIDEO_TS, use 0SEx to extract as VOB), NTSC FILM framerate, and, 3:2 pulldown enabled (options tab).

[jcpudd]

But what happened? Was it the new mencoder?

Is there anyway to take a video_ts folder and change it to a simple .vob file so I can convert it?

[jcpudd]

Now when I do it with the .vob file using osex I get this:

INFO: [yuvscaler] yuvscaler (version 1.7.0) is a general scaling utility for yuv frames
Thu Oct 28 03:10:16 EDT 2004
INFO: [yuvscaler] (C) 2001-2002 Xavier Biquard <xbiquard@free.fr>
INFO: [yuvscaler] yuvscaler -h for help, or man yuvscaler
usage: movtoy4m -w width -h height -F a:b -a a:b [-s] [-f] [-o ppm/y4m] movie.mov
example: movtoy4m -w 352 -h 288 -F 25:1 -a 4:3 pal_normal.mov
example: movtoy4m -w 352 -h 240 -F 30000:1001 -a 16:9 ntsc_wide.mov
**ERROR: [yuvscaler] Could'nt read YUV4MPEG header!
**ERROR: [mpeg2enc] Could not read YUV4MPEG2 header: system error (failed read/write)!


What now?

[major]

Is your Quicktime Player enabled to read mpeg-2? Try to open the VOB with it (no drag and drop, open.. and select VOB) and see if it plays.