VideoHelp Forum




+ Reply to Thread
Results 1 to 2 of 2
  1. 28th Jan 2004 21:33 #1
    tito13kfm
    tito13kfm is offline
    Member
    Join Date
    Jan 2003
    Search Comp PM
    Send a message via AIM to tito13kfm
    Don't install the new for the iomega "super" drive.

    I did a fresh boot, killed all running processes and clicked on the firmware, it then said Cannot install, error code 00 00 00 00 00 00 00 00 00 00 00 00. My computer locked up and I had to hard power off.

    When it restarted (and it took AWHILE) the dvd drive registers as having the new firmware installed but is only recognized as a 2.4x in nero. I don't know if it still burns or not, but it will read.. I'll test here in a little while.
    Quote Quote  
  2. 11th Feb 2004 11:38 #2
    bspisak
    bspisak is offline
    Member
    Join Date
    Feb 2004
    Search Comp PM
    I got the same error without the system lockup. My drive still shows the old firmware. Iomega support's final answer was to try a different system.

    2.4x would be correct if you were using a DVD+RW, right?
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!