nero 6.3.0.2 simulation

[skool123]

when i choose to simulate a burn in nero 6.3.0.2 it runs a simulation but actually does a burn and not a test. a message pops up that says simulation successful but when i go to burn, nero has already burned the video on the simulation run. is this a bug or what can i do to fix this problem

[ted york]

I'm having the identical problem. No Pun Intended but doesn't it just "Burn" you.

I was testing + and - R's at various speeds and made 6 coasters before I knew it. I aborted each simulation after I felt sure it was going to pass rather then sit through the entire process.

[skool123]

I'm having the identical problem. No Pun Intended but doesn't it just "Burn" you.

I was testing + and - R's at various speeds and made 6 coasters before I knew it. I aborted each simulation after I felt sure it was going to pass rather then sit through the entire process.

is cancelling a simulation right before it ends going to be like cancelling a burn right before it ends? since its not really simulating, will canceling it cause the burn (simulation) to fail?

[ted york]

No it's not. The simulation isn't supposed to write anything to the disc. The burn does and when cancelled what has been burned remains.

I found that I had a faulty power supply that was intermittently turning off but almost immediately back on. I wonder if this screwed something up. i would assume that the laser whether burning or simulating needs a decently regulated power supply.

If I find out anything more I'll be sure and let you know. Right now I'm a little hesitant to try any additional simulations just to see what happens.

LOL - Ted