Several of you have graciously responded to my questions a few months ago regarding using a DVR as a hard drive then burning using a Sharp or Panny. I have purchased a Sharp DVRW2U and feel like I have it setup correctly. However, the question I have is this: Once I have recorded something on the Explorer 8000 DVR how do I get the video source (at a later date not while the show is on) to go to the recorder. When I switch to the recorder video source and change input to L1, I get a blue screen. Do I have something hooked up wrong? I was assuming I would see video on the L1 since it is supposed to be receiving a video feed.

Any suggestions would be greatly appreciated.

Thanks,

Kevin