Hey all...I am running into a wierd problem When using DVDxCopy to make backups. The disc seems to complete 100% (The Log reports a comletion status of 100%) but I get an error message like this:

operation was not successful.
DVD Recorder is not Ready.
Driver Error code = 02020408h.
The disc is not successfully recorded.

When I test the Disc out in my players(Computer and set top) everything seems fine. Previously I had an error due to not setting the secondary IDE chain that my DVDR(Cendyne) is on to DMA -- which was causing crashes in mid burn -- but now that it's set to DMA it completes the burn, but gives this error. Anyone have any ideas about it?

I have my Cendyne DVD+/-R hooked up to the secondary IDE as a master with a WD Hard Drive as the slave.


Thanks in advance!

presideo