VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. Member
    Join Date
    Feb 2023
    Location
    ohio
    Search PM
    Anyone have any issues with this deck unspooling on the take up reel?
    Quote Quote  
  2. On the AG-6500, take-up unspooling is usually mechanical rather than electronic: the take-up reel isn't getting enough torque, so tape dumps into the transport.

    Things that commonly fix it:
    1. Clean the idler tire / reel table that drives the take-up. Dried or glazed rubber slips under load and is the #1 cause on these decks.
    2. Check the take-up clutch felt. If it's glazed or oily, the reel spins freely and won't wind. A tiny drop of idle-tire rejuvenator on the rubber (not oil on the felt) often helps; replace the tire if it's hard or cracked.
    3. Confirm the supply reel brake isn't dragging too hard, which can overpower a weak take-up.
    4. Try a known-good tape first so you aren't chasing a sticky binder problem on the cassette itself.

    If you say whether it fails in Play only, or also in FF/REW, and whether the take-up spindle turns by hand with the top off, people can narrow it to idler vs clutch vs brake. Service manuals and parts diagrams for the AG-6500 are still floating around if you need the idler part number.
    Quote Quote  
  3. Member
    Join Date
    Feb 2023
    Location
    ohio
    Search PM
    Thanks.. Also this is a direct drive motor.. so no typical rubber for these. each reel has a motor on it.
    Quote Quote  



Similar Threads