Instantcopy "Failed to set data for"

[rrolsbe]

Installed Instantcopy and the latest patch. I gave it the following location for the pdi file "I:\Instantcopy dest\". When I start I get the following error message
Failed to set data for "I\Instantcopy dest\BH_D2.pdi"

This I: drive has 50GB of free space and the Instantcopy dest directory exists.
Anyone have any ideas what is wrong? Am I doing something wrong?

Thanks Much In Advance
Ron

[rrolsbe]

I found a log file see below. Not sure what the following two lines indicate?
Could not load analyze data for disc: 1381F2922CC9F89267A91629F5A12A49-0003D800

Versions:
Operating System: Windows 2000 5.00 (Build 2195: Service Pack 3)
CD-R Drivers: 6.4.3.106 (3/20/2003 5:15:32 PM)
ISO/UDF Creator: 1.0.2.035 (2/19/2003 1:09:54 PM)
ASAPI Interface: 5.0.0.002 (4/27/2000 12:31:18 PM)

Source Device:

Settings:
Write method: Automatic (Recommended)
Closing method: Automatic (Recommended)
Write speed: Automatic (Recommended)
[ ] Write to hard disk first
[ ] Verify destination media after write
[ ] Fixed Gaps between tracks
[X] Repair Subchannel data

Transfer Mode: Automatic (Recommended)
Error Handling: Stop copying on read error
[ ] Use error seek
Error seek range: 0
[X] Automatically create processing items

Reading Video Title Sets...
Could not load analyze data for disc: 1381F2922CC9F89267A91629F5A12A49-0003D800
Getting audio data size 1 of 6
Getting audio data size 2 of 6
Getting audio data size 3 of 6
Getting audio data size 4 of 6
Getting audio data size 5 of 6
Getting audio data size 6 of 6
Nr Position Length Pre Post Se Sector Mode
---------------------------------------------
01 0 2,464,153 150 150 1 Mode 1 ISO
---------------------------------------------
1 Track(s), 2,464,453 sectors total data length