I have not been able to overburn any VCD's or SVCD's. I have a SVCD that is just like 1 mb over the 80 mins requiring overburn. It is in a BIN/CUE, but won't work either when extracted with IsoBuster.

When trying in Nero, I get the error 'Cannot perform start of disk at once'. This happens before it even attempts to burn.

When trying VCDEasy, I get:

Executing power calibration...
Power calibration successful.
cmd finished after 0.000s timeout 180s
ERROR: Cannot send cue sheet.
ERROR: Writing failed.

When using BurnatOnce, I get this:

Executing power calibration...
Power calibration successful.
?: I/O error. : scsi sendcmd: retryable error
CDB: 5D 00 00 00 00 00 00 00 30 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 26 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x26 Qual 0x00 (invalid field in parameter list) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.010s timeout 180s
ERROR: Cannot send cue sheet.
ERROR: Writing failed.


Basically all the same errors I think. Is it that I cannot overburn with my Pioneer DVR-103? Very frustrating, these are the only 3 programs that I know of that work with my drive..

The worst part is TMPGEnc gives an 'Illegal video stream' error with this MPEG, so I cannot even shorten the file..