VideoHelp Forum




+ Reply to Thread
Results 1 to 2 of 2
  1. 9th Aug 2001 07:47 #1
    jupiter172
    jupiter172 is offline
    Member
    Join Date
    Jul 2001
    Search PM
    Send a message via MSN to jupiter172
    HI, I NEED HELP USING TMPGEnc..I HAVE BURNED SOME VCDS USING TMPGEnc TO ENCODE AND THEY PLAYED FINE ON MY DVD PLAYER, BUT THE QUALITY ISN'T THAT GOOD, I HEARD SOMEWHERE THAT INCREASING THE BITRATE WILL HELP THE QUALITY, I AM NOT SURE THOUGH..CAN SOMEONE TELL ME WHAT SETTINGS THEY USE TO MAKE VCDS(I USE 2 CDS PER MOVIE). THANKS A LOT!
    JuPiTeR172
    vcd_man40@hotmail.com
    Quote Quote  
  2. 10th Aug 2001 07:43 #2
    lafamar
    lafamar is offline
    Member
    Join Date
    Jul 2001
    Location
    Brazil
    Search PM
    If you change the bitrate rate then you'll not have a VCD comliant/ISO. You'll get a XVCD or something similar.
    You'll may test XVCD or SVCD(mpg2), but first you must verify if your DVD Player Unit plays XVCD and/or SVCD and what bitrate was tested by users. Go to DVD Players in this page(on left side,red column) and check all about this.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!