AutoGk convert to 700Mb... result out of sync audio

[ianskiee]

i used AutoGk to convert my 1.3Gb movie to be a 700mb with subtitle... it took me 3 hours.. the result 700Mb size [wow] then i played it on media player.. the start was good.. but after a few minutes the audio was out of sync from the movie.

what had gone wrong?

[guns1inger]

So it starts off in sync, then shifts out of sync over time ?
Or it drifts out of sync from the start ?
Or it starts off in sync, then suddenly jumps out of sync and remains out by the same amount from then on ?

[ianskiee]

So it starts off in sync, then shifts out of sync over time ?
Or it drifts out of sync from the start ?
Or it starts off in sync, then suddenly jumps out of sync and remains out by the same amount from then on ?

well i wud go to "So it starts off in sync, then shifts out of sync over time ?"

from the start it was ok.. den after few minutes the sound are delayed until the end of the movie. and even sometimes the subtitles are also delayed.

[guns1inger]

So the sound gets further out of sync the longer the movie plays ?

[ianskiee]

So the sound gets further out of sync the longer the movie plays ?

yes.. how do i solve this.. ?

[guns1inger]

This is usually a symptom of format conversion - altering frame rates either from PAL to NTSC (or NTSC to PAL) or form 23.976 to 29.970 fps NTSC.

Check your settings and logs to see if this happened.

[ianskiee]

ic.. ok.. so your trying to say is that.. i would always check that it is on default format? not altering the fps, nor the NTSC.

if its 23 fps it should be 23. and if NTSC is should also be NTSC.