Workshop DVD is too heavy for drive C, Want to move to D drive

[yunakokimama]

I installed workshop DVD to C drive, but there is only 5 GB in C, so workshop DVD is TOOOO heavy, I want to move workshop DVD to D drive, How can I move to D from C???

[guns1inger]

Uninstall it and reinstall it. There are applications that can move applications from disk to disk, but DVD Workshop tends to dump a lot of crap around the place, so you are better off letting it re-install itself.

[yunakokimama]

OK THank you for quick response!!!!
When I reinstall it, it appear screen , REPAIR, REMOVE, not download screen appear. I cleaned all relative file with YOUR UNINSTALLER 2006 PRO, but still there is no way to install again. What should I do?

[guns1inger]

Go to Add/Remove Programs, highlight the program, and select remove. It will uninstall it from your PC.

Go to the original installer - either the CD it came of, or the file you downloaded from their site when you bought it, and install it fresh from there. When the installer runs, change the desination folder to something on your D drive.

[yunakokimama]

HI, Thank you again!!!!!!!!!

I could reinstall again finally, but when I try to run it, error appear, it says " The procedure entry point ?Getscaling@textLayer@ArizonaText@@QBENXZ could not be located in the dynamic link library ArizonaDLL.dll "

I am panic, I only have D hard drive, but C drive is not enough space, which make program run very slow, so I need to install to D successfully. WHat should I do now??

[guns1inger]

Try their support forums of help line ?

This sounds like either it didn't re-install properly, or it only works properly if installed o the c:\ drive. Only they can confirm this or give you advice.

[lordsmurf]

My C: is 120GB and it's almost too small. I cannot really store anything on it besides the OS and software.

5GB is not a good situation at all.