i was burning a dvd video disc from my shrinked files, and just this once, after is burned, nero said "creating dvd high compatibility mode". it went to 100%, but it wouldnt finish (the drive's light was still red).
i was forced to power the pc off, and reboot. i burned the same project again, only this time, it didnt create dvd high compatibility mode, and the burn completed normally, like it always did. (before the high compatibility event)
i am using lite-on 411s firmware: FSOJ
that only happened once, what's up with that?
+ Reply to Thread
Results 1 to 2 of 2
-
-
I would update to the 6.3 since the 6.2 and before don't actually list the 411 as a "supported burner". What I do for maximum compatibility is to make an iso image and use DVD Decrypter to burn the image. I get much more consistent results than I did with Nero.
Similar Threads
-
TMPGEnc "clip total bitrate too high for a DVD-Video" issue
By dread in forum Authoring (DVD)Replies: 7Last Post: 26th Oct 2010, 15:34 -
TMPGEnc says "clip total bitrate is too high for a DVD-Video" but it's not?
By sasuweh in forum Authoring (DVD)Replies: 24Last Post: 30th Sep 2010, 03:17 -
DVD on Sony Walkman X, "SP" template but high bit rate
By dch888 in forum DVD RippingReplies: 1Last Post: 6th Dec 2009, 15:19 -
I cant get anymore "watch in high quality" link on youtube after
By foler in forum Video ConversionReplies: 1Last Post: 17th Feb 2009, 09:34 -
Nero Recode 3.1.2.0 -- "Nero Digital Standard" vs. "Nero Dig
By GrayStrickland in forum DVD RippingReplies: 1Last Post: 15th Dec 2008, 19:23