VideoHelp Forum




+ Reply to Thread
Results 1 to 2 of 2
  1. 31st Jul 2003 11:24 #1
    zeolum
    zeolum is offline
    Member
    Join Date
    Jul 2003
    Search Comp PM
    Hi there!

    It seems there has been a mistake while updating my Supervision 2500 firmware, and the player don't work anymore (it doesn't even power up!). Do you know any method to recover my firmware? I've downloaded the old version, but since the player doesn't power up I can't work it out. Is there a method to reset my player to factory settings?

    Thanks!
    Quote Quote  
  2. 4th Aug 2003 22:22 #2
    EddyH
    EddyH is offline
    Far too goddamn old now EddyH's Avatar
    Join Date
    Jan 2003
    Location
    Soul sucking suburbia! But a different part since I last logged on.
    Search Comp PM
    Send a message via ICQ to EddyH Send a message via MSN to EddyH
    other than asking the manufacturer for a download of the original version and borrowing an EPROM burner from someone, you're probably out of luck

    all i can say is i'm glad i read this as i have the same model and was thinking of updating.. but as it seems to work mostly fine as it is (if a little inflexible) i think i'll leave it well alone. what was the update supposed to do?
    -= She sez there's ants in the carpet, dirty little monsters! =-
    Back after a long time away, mainly because I now need to start making up vidcapped DVDRs for work and I haven't a clue where to start any more!
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!