VideoHelp Forum




+ Reply to Thread
Results 1 to 4 of 4
  1. 11th Nov 2002 09:57 #1
    SingSing
    SingSing is offline
    Member SingSing's Avatar
    Join Date
    Apr 2001
    Location
    U.S.A.
    Search Comp PM
    I ripped DVD by Chapter, I then group them in DVD2AVI.

    I only figured out how many frame ( or time ) that I can't
    fit into a SVCD, after I run a few frame in TMPenc.
    I typically fit 65000 fram per 780MB SVCD.

    Is there a way to figure the number of fram in smart ripper
    or DVD2AVI first ?
    Quote Quote  
  2. 11th Nov 2002 12:39 #2
    DJRumpy
    DJRumpy is offline
    Member DJRumpy's Avatar
    Join Date
    Sep 2002
    Location
    Dallas, Texas
    Search Comp PM
    You would typically rip your entire source, and then split it after the fact, not during.
    Impossible to see the future is. The Dark Side clouds everything...
    Quote Quote  
  3. 11th Nov 2002 13:02 #3
    SingSing
    SingSing is offline
    Member SingSing's Avatar
    Join Date
    Apr 2001
    Location
    U.S.A.
    Search Comp PM
    How do you "spilt it" ? These are vob files.
    Quote Quote  
  4. 11th Nov 2002 13:09 #4
    DJRumpy
    DJRumpy is offline
    Member DJRumpy's Avatar
    Join Date
    Sep 2002
    Location
    Dallas, Texas
    Search Comp PM
    There are a multitude of ways. You didn't mention what encoder you use. Use VOBSplit (see the Tools section on the left). You can also use TMPGenc to split VOB files ( FILE | MPEG TOOLS ). You can also use the built in bitrate calculator in TMPGenc to ensure your MPEG fits. This assumes of course that you even use TMPGenc, and that your using CBR. VBR is harder to predict.
    Impossible to see the future is. The Dark Side clouds everything...
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!