VideoHelp Forum




+ Reply to Thread
Results 1 to 4 of 4
  1. 11th Jan 2007 23:16 #1
    unknown2016
    unknown2016 is offline
    Member
    Join Date
    Jan 2007
    Location
    Canada
    Search Comp PM
    It was working fine yesterday but todat after opening the tray it wouldn't close. Does anyone might know what is wrong?
    Quote Quote  
  2. 12th Jan 2007 00:19 #2
    Bjs
    Bjs is offline
    Member
    Join Date
    Feb 2004
    Location
    Australia
    Search Comp PM
    Depending on unit .

    Tray's drive belt broken .
    Tray's drive gear malfuction (worn teeth)
    Tray's close / open sensor malfuction .

    Depend's if you pressed the button on the unit to close the tray or the remote .
    In case of remote ... batteries or defect keypad component .
    Quote Quote  
  3. 12th Jan 2007 00:30 #3
    thecoalman
    thecoalman is offline
    Member thecoalman's Avatar
    Join Date
    Feb 2004
    Location
    Pennsylvania
    Search PM
    Make sure the tray can fully close, it may not even be apparent that it can't. I installed a brand new drive on my computer and switched the plate after which it wouldn't close. It was a very miniscule amount that wasn't allowing it to fully close, so little that it looked like it was fully closing...
    Quote Quote  
  4. 12th Jan 2007 11:05 #4
    handyguy
    handyguy is offline
    Member
    Join Date
    Mar 2003
    Search Comp PM
    Make sure there isn't a dvd in the back somewhere.

    ALso try pushing it in with your finger.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!