Help Using Procoder V2.0

[MACKY]

I am trying to convert a PAL DVD to NTSC. I copied the VIDEO_TS folder from the DVD to my Hard Drive. It contains two BUP Files, two IFO Files, and 5 VOB files. When I start Procoder Wizard and point Load Source at the VIDEO_TS folder on my hard drive only the 5 VOB files display. I can only select one. Which one? Do I need to do all five of them one at a time? Or am I doing something wrong?

Thanks for any help.

[silvergator]

Select the first big VOB file. You should then have the time of the total movie listed in the adjacent window.

[MACKY]

VTS_01_1.VOB = 1,048,574KB, VTS_01_2.VOB = 1,048,574KB, VTS_01_3.VOB = 1,048,574KB, VTS_01_4.VOB = 1,048,574KB, and VTS_01_5.VOB = 376,708KB. Do I still only select the first one and that will do the whole DVD? Should I use the Full App instead of the Wizard or will the Wizard do OK.

[silvergator]

Yes still pick the big one

VTS_01_1.VOB

[MACKY]

So if I also had a VTS_02_1.VOB, VTS_02_2.VOB and VTS_02_3.VOB, I would select the VTS_02_1.VOB (which would also be one of the larger files) and it would do all of the VTS_02_x.VOB files. Each time it processes a group of VOB's, it creates a VTS_0x_0.IFO and VTS_0x_0.BUP for that group correct? What about the VIDEO_TS.IFO and VIDEO_TS.BUP .... when and how does that get created? And if it turns out that it will create a set of VIDOE_TS.IFO and BUP for each set of VOBs, how do I combine them? I can only have one VIDEO_TS.IFO and BUP per DVD right?

Thanks for your help so far ... I've been reading allot of sites with DVD info too ..... Scary, this might be starting to gel