Error around 97%- Help Needed

[SmackEdo]

Hey, ive burned some movies using nero 6 ultra and they work but recently when i try to burn movies i always get an error and 97%. The movie still works but the end is cut off. I havent changed any method of burning, i use DVD shrink. The error is "faild buring at 4X".

Any suggestions on wut it might be? Thnx

[DaveS]

what media are you using? errors are more typical at the outer edge of the disk..might try shrinking it to be a bit smaller than you are now to avoid the outside edge...also, slow your burns down to 2x or 1x ... maybe try a slower burn on your current media first & if you are getting coasters then shrink more or try different media...hope this helps...

[SmackEdo]

im using Maxell DVD - R. I dont think its the edge of the disk because i had a movie that was 3.7G and i still got that error, i used these disks before and didnt get any problems till just recently. My friend had this problem to with his nero, i tried uninst and reinstall but same thing. I even used diff Burning software and worked fiine but again that error came up after like 5 burns.

[lordsmurf]

This could be a dirty burner laser or bad/glitched firmware.
Clean drive, reflash.

Could be media, but if it's trye MXLRG01, MXLRG02, I doubt it's the media.

The DVD Shrink burning engine is also not perfect.

Lots of options, this is just a few ideas.