Iam about to freakin give up on this

[spiralnebula42o]

I have a real problem, I know I have done everything right doin this pal to ntsc conversion using tmpgenc I've read all the responses everyone has given to my posts I've followed the guides word for word I've done everything I think I can possibly to for this stupid conversion and still the freakin picture is jerky, not much but its there and it is quite an annoyance and I really have no idea what to do know, also to top this all off I was watching my PAL svcd source and just realized that its jerky my freakin source is jerky! I know that can't be good, I don't know what to do about any of this Iam gonna figure I should trash this thing because if my source is jerky than I figure no matter what I do to convert it to ntsc it will always be jerky. Maybe the person who made this pal svcd did something wrong converting it, maybe they set it to be non-interlaced/progressive when really it was interlaced so it made the picture be all jerky maybe it's really interlaced and not progressive, I used dvd2avi to figure out what my source was and it said it was pal 25fps progressive but like I said maybe in reality the person did the conversion wrong, I dunno just an idea, tryen to think of some possible ideas cause I really don't want to scrap this. If anybody has any idea's or solutions for these problems they would be greatly appreciated because my mind is completely blank on what to do right know.

-Jay

[lordsmurf]

Garbage in, garbage out. Jerky cannot really be fixed.