DVD REBUILDER NEED HELP

[Still Learning Here]

First I use DVD Decrypter to rip from DVD To hard drive(in file mode). Then I follow the DVD Rebuilder Guide for all the setup. Then I hit the PREPARE Button on DVD Rebuilder, which it generate a lot of .AVS file. When it done that then I hit ENCODE button, the CCE basic is load up and give me this error message when it try to encode "Frame size 1124x56 is not supported. Supported frame size is up to 720x576" The movie I try to backup is GODZILLA. I know the movie is NTSC(740X480) not 1124x56 like the error give. Please help me....

[budz]

you may need the ECLCCE file installed if you are using a demo version of CCE or you didn't select the correct version of CCE in the setup.

go to options and click on CCE options, click on the correct of version CCE you have. then go to OPTIONS, click on SETUP make sure you have the PATH to CCE correctly checked off that is why you're getting that error msg. make sure you install the ECLCCE and MPEG2DEC3G correctly. install the ECLCCE in your CCE FOLDER by creating a new folder Unzip the ECLCCE in there. double click on the ECLCCE exe. file then direct it to your CCE exe.file. the CCE program will then open up, just close it. then when you set the PATH to CCE the ECLCCE is in there. The file name would look like this: C\:Program Files\Custom Technology\CCE SP TRIAL Version\New Folder\EclCCE.exe

hope you undestood my directions and this can be of some help. i had trouble installing the program. i used the 2 guides that were provided and the FAQ INSTALLATION section on DVD REBUILDER. let me know if you get this program to work.