ULEAD DVD MOVIE STUDIO & ATI ALL IN WONDER

[Speedpuppy]

ok now i;m confused prior to installation of ati aiw board i used dazzle and burned vcds with uleads movie studio

now i capture using the aiw board ok differnt settings and yes mpeg 2s that i convert to vcds... play great on puter but when i right i get same error message...
it writes about 95% of the file then the cd pops open and says DRIVE NOT READY...what ever that means..

tech supp had no idea the typical un/reinstall which i did
no avail

any ideas

thanks

[Lamont Cranston]

On the burn page you can select the driver for the cd burner. It is probably set to Ulead. Change it to the NTI driver.

[Speedpuppy]

yes nti is a choice i will try that now and report thanks

[Speedpuppy]

ok that produced a complete burn..thanks (what the heck is nti as opposed to ulead)
but now i took the cdrw down to apex 660 and it came up with a "folder" but unable to play..
which i think is correct i need to be quick and turn off pbc i think for rws or burn to cdr which i havent been since making several coasters last nite

thanks for the nti choice that may have solved it

[Lamont Cranston]

NTI makes backup and CD burn programs. Ulead used NTI CD Burner drivers while they developed their own.

[tjdmobile]

Yeah, I have an HP 8290 burner, and the Ulead driver has produced 5 CDRW coasters. NTI takes about 3 times as long on my system (what....is it only burning 1x?) but no problems yet.

Other than that, all is working well, and my APEX AD1500 loves the disks.