Hello,

Samsung DVD-HR737 does not remember RGB Video Output option after standby/on operation. It is always set to Component after standby/on operation. I have connected the recorder to TV via full SCART cable. Other options are remembered ok.

The recorder remembers the RGB setting when I have set the Quick Recording option on. However, the power consumption is higher which is not desirable. It is acceptable as a workaround but not as a final solution.

1. Is there a firmware upgrade option which correct this?
2. Could someone test it on another unit to verify if it is general failure or just my recorder problem?
3. Does anybody know the power consumption in standby mode with Quick Recording on?

Thank you.

==
I have obtained firmware which fixes this problem. I got it unofficialy. Samsung support is bad.