i was wondering how would i be able to caputre a clip from a dvd?? i dont want to back up the whole dvd, i just need to back up couple of clips? how would i go about doing that???
can someone let me know pls thanks
+ Reply to Thread
Results 1 to 5 of 5
-
-
Hi dvdman24,
I believe that you can set DVDDecrypter to select the desired clip and then extract it. Repeat for each desired clip.
As for the exact settings, I can't help there as I've never done it. That said, it can't be too hard to work out coz DVDDecrypter is pretty intuitive.There is some corner of a foreign field that is forever England: Telstra Stadium, Sydney, 22/11/2003.
Carpe diem.
If you're not living on the edge, you're taking up too much room. -
You can do it with DVD Shrink in re-author mode, just set your start and end points.
You can also use TDA among a few other ways, -
Thats about it.
DVDDecrypter can give you only chapter level extraction. But DVDShrink lets you select range within a chapter also.When I was born I was so shocked that I could'nt speak for 18 months. -
Apologies dvdman24 - I must've been thinking of DVDShrink but said DVDDecrypter instead. I knew it was one of those...
There is some corner of a foreign field that is forever England: Telstra Stadium, Sydney, 22/11/2003.
Carpe diem.
If you're not living on the edge, you're taking up too much room.
Similar Threads
-
Sync/align one short clip into one big clip
By diamondback in forum AudioReplies: 1Last Post: 2nd Nov 2011, 09:31 -
Can't Caputre MiniDVDs.
By menash07 in forum Capturing and VCRReplies: 1Last Post: 26th Jun 2010, 17:50 -
adding clip to DVD
By pcb in forum Authoring (DVD)Replies: 2Last Post: 26th Apr 2010, 15:00 -
Transition from Clip to Clip in Premier
By Namrepus221 in forum EditingReplies: 2Last Post: 1st May 2008, 16:29 -
Do I need to stop clip analysis in order to export clip for dvd
By maevek1 in forum MacReplies: 0Last Post: 9th Apr 2008, 08:26