Hi, all. I noticed something strange while playing around with the calculator. Well, maybe strange to me because I'm new, but when I use the bitrate calculator to figure out the bitrate for a 1 hour and 50 minute long svcd footage for 80 min discs, with 224 audio enc, I get 1744 as a result. However, I discovered that one of the svcds that I found, which had 224 audio enc and was approx. 1 hour and 50 min long, had 2500 bitrate. That svcd was split into two 80 min discs, each with 2500 bitrate. How is that possible?
+ Reply to Thread
Results 1 to 3 of 3
-
-
was it an average bit rate maybe? some parts of movie could be lower than that and action sceens higher
-
Originally Posted by §kipTracer65
Similar Threads
-
Should i put average bitrate or max bitrate in 2pass encoding mode?
By tendra in forum Video ConversionReplies: 28Last Post: 11th Nov 2011, 07:38 -
Using mutiple passes with lower bitrate vs single pass with high bitrate on
By jones24 in forum Newbie / General discussionsReplies: 15Last Post: 14th Aug 2009, 18:17 -
Low bitrate source to High bitrate target
By sameerdhiman in forum Newbie / General discussionsReplies: 2Last Post: 7th Nov 2008, 23:54 -
Entering Video Bitrate Makes Preset Switch To SVCD
By akulier in forum ffmpegX general discussionReplies: 7Last Post: 26th Feb 2008, 05:12 -
Entering Video Bitrate Makes Preset Switch To SVCD
By akulier in forum ffmpegX general discussionReplies: 1Last Post: 21st Feb 2008, 04:31